Silica Sand Dryer

Silica Sand Dryer

On the inner wall of the cilinder/drum, there are many lifting plates which is welded according to one special methods. When the Silica Sand Dryer drum is rotating, these lifting plates makes the sand up and down to mix with the hot air completely. Durng this process, the moisture is evaporated.
On the another side of the silica sand dryer, there is one high pressure draught fan which sucks out the steam, and then the steam goes into the cyclone dust separator.
In the cyclone dust separator, the dust inside the steam falls down and goes out through the discharging hole of the cyclone dust separator. The steam goes into atmosphere directly through the chimney which is connected to the cyclone dust separator.
Furnace for the Silica sand dryer usually has two types. For the handling capacity below 30 t/h, our company's new design hot air furnace is very suitable. We have produced well the hot air furnace at our factory, and later when the user gets the hot air furnace, the user only need to connect the hot air furnace to the Silica sand dryer directly by themselves. It will save the user much time and cost.